Kolpin 3505 – UTV Dual Speaker User Manual

Utv dual speaker installation instructions, Warning, Stock no.: 3505

Advertising
background image

Please read and understand these instructions completely before installation to avoid injury to yourself or damage to the vehicle

or accessory.

Dealer: These instructions contain important information for future reference and must be given to the customer at time of purchase or

upon completion of installation.
Parts List:

Please Note: The UTV Dual Speaker was designed to fit most UTV roll cages. Because roll cages may vary in design, use your best

judgement in determining where to locate the speaker in order to provide a secure and stable installation.

1) Mount the two sets of brackets on the vehicle’s roll cage as indicated in Image “A1”. Insert the tongue of the male bracket into the

groove of the female bracket and close the two halves. Please note that the threaded inserts of the bracket should face the same

direction you intend to direct the speakers.

2) Secure the brackets with the supplied M6 x 35mm lg. T-handle knobs,

M6 x 12.5mm spacers, M6 x 25mm spacers and M6 nylock nuts as

indicated in Image “A2”. Do not tighten at this point. The brackets will

need to be adjusted before this is done.

3) While holding the speaker in your desired mounting location, slide the

brackets along your roll cage until the threaded inserts line up with the

mounting plates on the back of the speaker as indicated in Image “B”.

4) Once the brackets are aligned, finish tightening all of their hardware.

Do not overtighten the T-handles as this will cause them to break the

mounting brackets.

5) Finish mounting the speaker by attaching it the the mounting brackets

with the supplied M6 x 20mm lg. button head cap screws and M6 lock

washers as indicated in Image “C”.

6) Complete the installation by running and securing the speaker wires to

your stereo using the diagram indicated in Image “D”.

7) Maintenance and Care: Tighten all hardware after first use and

periodically thereafter.

Failure to follow these

installation instructions

completely may void any warrantable

components and result in property damage

or personal injury. NEVER operate or transport

UTV with unsecured cargo.

For additional assistance, please contact our

customer service department at:

Kolpin Outdoors, Inc.

205 N. Depot Street | Fox Lake, WI 53933

1.877.956.5746

[email protected]

UTV Dual Speaker Installation Instructions

Stock No.: 3505

ITEM

PART NAME

PART NO.

DESCRIPTION (60-3505)

QTY.

1

Speaker

100-3505

UTV dual speaker assembly

1

2

Bracket

52-0017

Male bracket half

2

3

Bracket

52-0018

Female bracket half

2

4

T-Handle Knob

52-0013

M6 x 35mm lg. T-handle knob, stainless steel

2

5

Spacer

57-0006

M6 x 12.5mm lg. spacer, aluminum

2

6

Spacer

57-0005

M6 x 25mm lg. spacer, aluminum

2

7

Nut

77-0006

M6 nylock nut, stainless steel

2

8

Screw

75-0003

M6 x 20mm lg. button head cap screw, stainless steel

4

9

Washer

76-0002

M6 lock washer, stainless steel

4

Roll Bar

M6 x 25mm

Spacer

M6 x 12.5mm

Spacer

M6 Nylock Nut

M6 x 35mm

T-Handle Knob

Image A2

Female Bracket

Male Bracket

Roll Bar

Image A1

M6 Lock Washer

M6 x 20mm Button

Head Cap Screw

Image C

Image B

WARNING

!

White Wire

Black Wire

+

Red Wire

Left

Right

Green Wire

+

Image D

Advertising