Cleveland Motion Controls ULTRA SERIES CANTILEVER TRANSDUCER CLTSCM REV AA - Manual (Page 6)

U LTRA S ERIES C ANTILEVER T RANSDUCER MAN-70252 R EV . AA
P AGE 6 OF 18
Table B – Determining a Mounting Kit Catalog Number for the Ultra Series Cantilevered Transducer
Size
Mounting Style
1T (inch) 2T (inch) 1T (millimeter) 2T (millimeter)
Bearing (BR) MO-04495 MO-04500 MO-05175 MO-05174
Flange (FL) MO-04493 MO-04498 MO-05176 MO-05177
Pillow Block (PB) MO-04494 MO-04499 MO-05172 MO-05173
Table C – Determining a Shaft Adapter Catalog Number for the Ultra Series Cantilevered Transducer
If Finished Bore Diameter
(nominal I.D) equals:
1T Alum
Use Catalog
number:
1T Steel
Use Catalog
number:
2T Steel
Use Catalog
number:
1/2 inch MO-12143-0 MO-12144-0
5/8 inch MO-12143-1 MO-12144-1
3/4 inch MO-12143-2 MO-12144-2 MO-12145-0
1 inch MO-12143-3 MO-12144-3 MO-12145-1
1-1/8 inches MO-12143-4 MO-12144-4 MO-12145-2
1-1/4 inches MO-12143-5 MO-12144-5 MO-12145-3
1-1/2 inches MO-12145-4
17 millimeter MO-12146-0 MO-12147-0
20 millimeter MO-12146-1 MO-12147-1 MO-12148-0
25 millimeter MO-12146-2 MO-12147-2 MO-12148-1
30 millimeter MO-12146-3 MO-12147-3 MO-12148-2
35 millimeter MO-12148-3
1.2 C ONTACT I NFORMATION AND S ERVICE A SSISTANCE
For service assistance, have the following information available:
•
Type of Cartridge Transducer you are using
•
Maximum working force
•
Purchase order number
You can contact Cleveland Motion Controls at:
Phone: 216.524.8800
Fax: 216.642.5155
For the latest product information, technical literature etc., visit our website at www.cmccontrols.com
Disassembly by improperly trained personnel may result in additional damage to these units. Should repairs
be required or for warranty repairs, contact the Customer Service Department for a return authorization
number before returning the units.
1.3 R ECEIVING AND U NPACKING
After receiving the Ultra Cantilever Transducer you should:
•
Carefully, unpack and inspect the equipment
•
Compare the received shipment with the packing list
•
Report any damage to the carrier and your CMC representative
•
Store equipment that will not be used in a clean, dry location
•
Take appropriate precautions to prevent moisture, dust and dirt from accumulating in storage and
installation areas