Cleveland Motion Controls Classic Tension Transducers SC-EP REV GA - Manual (Page 5)

Cleveland-Kidder Transducers; EC, ECM, SC, SCM & SC-EP A800-7438 Rev GA
P AGE 5 OF 10
1.4 DESCRIPTION
The Cleveland-Kidder Tensi-Master tension
transducers* for stationary shafts are available in
three sizes, 1, 2 and 3 and in four different
mounting configurations, S, FL, PB, and BR.
(*U.S. patent # 4326424. Foreign patents upon
request.)
The different configurations are made by adding
mounting hardware modules to the transducer
cartridges. In each of the sizes, the transducer
cartridges are available with the connector
mounted either on the side or the end. For
dimensions of the transducer with the mounting
kits installed, see Figure 2.
The SC-1T, SC-2T, SC-3T, SCM-1T and SCM-
2T cartridges have the connector located on the
side. These cartridges can be mounted to the
machine frame with a single bolt which goes
through the machine frame for the type "S"
mounting, as shown in Figure 1.
The flange mounting kit can be clamped onto the
groove near the edge at the end of the type SC-1T,
SC-2T, SC-3T, SCM-1T and SCM-2T cartridge.
The cartridge can then be mounted to the machine
frame by the flange with four mounting bolts for
the type "FL" mounting, as shown in Figure 1.
The type EC-1T, EC-2T, EC-3T, ECM-1T and
ECM-2T cartridges have the connector located on
the end. The cartridge can be converted to a
pillow block type transducer by adding the pillow
block (PB) mounting kit. The cartridge is inserted
into the pillow block base and then the lockplate
is bolted to the end of the cartridge. The
transducer is mounted to the machine frame with
two bolts through the pillow block base for the
type "PB" mounting, as shown in Figure 1.
The type EC-1T, EC-2T, EC-3T, ECM-1T and
ECM-2T cartridges can also be mounted through
the machine frame by using the type BR mounting
kit. The cartridge is inserted through a hole in the
machine frame and then the lockplate is bolted to
the end of the cartridge for the type "BR"
mounting, as shown in Figure 1.
For mounting dimensions see Figure 2.
TYPE "S" MOUNTING
TYPE "FL" MOUNTING
TYPE "PB" MOUNTING
TYPE "BR" MOUNTING
STATIONARY SHAFT
SENSING ROLL MACHINE FRAME
Figure 1