Cleveland Motion Controls Quantum Tension Controller REV A - Manual (Page 4)

www.cmccontrols.com
4
SETTING UP
Keypad : Follow -> Input > Measure > ... (load cells)
Follow -> Input > Diameter > ... (US
sensor)
2 - Set point value
Open loop: enter a percentage of the full scale
Closed loop: enter directly the target value
Note: The Set Point value can be adjusted at any
time from the front panel keypad
3 - Input/Output definition
Software: See -> Input and Output Menus and
enter the data fields related to the
chosen application
Keypad: Enter the parameters shown on the table
4 - Dynamic parameters (regulation and stability)
Software: See -> Regulation Menu and enter the
data fields related to the chosen
application
Keypad: Enter the parameters shown on the table
OVERVIEW
Fully compatible with
Any current load cell technologies
One or two, half or full bridge load cells
US sensors (direct input available)
Built-in PWM Power Supply
Up to 1.5 Amp available as PWM output voltage
No need for external power supply with EMAG Brakes
All details about these advanced features are
fully available in the Help file included with the
PC software supplied with the unit.
User friendly
Selectable language (En / Fr / Ge / It)
Selectable Metric or Imperial units
HOLD and RELEASE on front panel keyboard
Advanced regulation capabilities
Automatic P.I.D. parameters variation function
Closed loop + open loop mode
Inertia compensation control
Smooth start-up with programmable slope
E-stop torque proportional to the set point
Adjustable tapper function available
No-Stop web turrets management function
Five complete built-in memories
Motors & Drives specific settings available
PC software sett-up and debugging
Unlimited configuration records by software
Real time full control panel available
Unlimited real time data record by software
Two different ways are offered for system set-up of
your QUANTUM:
Using the exclusive user friendly set-up software
(QUANTUMsoft on a computer.)
Choose the required type of application, fill in
the datafields with your own data, and upload
the file to the QUANTUM.
At any point in the set-up you can click on help
in the toolbar, which gives you more details
about the procedure.
Using the front face keypad when there is no
computer available (password requested, see
p10).
The procedure is based on the “Initial set of
parameters” related to each type of application
(on pages 5-8). Enter the data as per the drawing
on p10.
System set up procedure to be followed
1 - Sensor(s) calibration
Follow the automatic calibration procedure
Software : Download the related “.prm” file
See -> Input Menu in the
QUANTUMsoft and enter the data
fields related to the chosen
application