CNB IGB1110NF User Manual
Page 8
8 / 18
X
X
N
N
E
E
T
T
N
N
e
e
t
t
w
w
o
o
r
r
k
k
B
B
o
o
x
x
C
C
a
a
m
m
e
e
r
r
a
a
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
M
M
a
a
n
n
u
u
a
a
l
l
NETWORK : This Ethernet terminal connects to 10Mbps or 100Mbps LAN through an RJ-45 connector.
When optional PoE is used, the power will be supplied from the Network Cable.
LINK : Yellow light indicates that he network is properly connected.
ACT : Green light indicates that the XNET system connected to 100Mbps LAN. This green lamp will
blink if the system receives data.
STATUS LED : Indicates the operation status
EVENT LED : Green light indicates that Alarm Out signal is turned on.
POWER LED : Red light indicates that 12V DC power is connected.
RS-485 and ALARM In/Output Terminal
Pin
Description
Set up
1 Alarm
Out
Select NC/NO at menu screen
2 Alarm
Out
3 Alarm
In(+)
Select NC/NO at menu screen
4 Alarm
In(-)
5 RS485
+
-
6 RS485
-
RS-485: When properly connected, you can remotely control Pan/Tilt device with RS-485 control
interface.
Alarm In: This connects to an Alarm Sensor signal. Only one sensor can be connected.
Alarm Out: This connects to an external Alarm device that operates by a relay such as Siren
Lamp or Alarm Light. Only one Alarm device can be connected.
SD CARD SLOT : Enables recording of video data to an external memory device upon occurrence of an
event. Please use less than 4 GB SD Memory.
Figure 2-4. SD CARD
Power Terminal: Connect 12V DC Power to this terminal.
Do not use this connector when powering up the product through LAN cable. (PoE)
The product is not covered under warranty when it is damaged by connecting both
Ethernet power and 12V DC power to this terminal.
1 6