CNB IG1810PF User Manual
Page 7
XNET Network Box Camera User’s Guide
2.3.2. Rear panel
RS232C &
Analog Video Out
Status LED
Link LED
RS485 &
Alarm Input / Output
Reset Button
Figure 2-3. Rear Views of XNET/XNET-Wireless
y MIC /LINE IN:
Connect external audio source or microphone. Use a standard stereo
earphone jack for the connection
Audio In
Ground
Not used
Audio In
Ground
Not used
Audio out
Ground
Not used
Audio out
Ground
Not used
Figure 2-4. Pin assignment of the plug for MIC / LINE IN (left) and
LINE OUT (right)
y
LINE OUT: Connect speakers with built in amplifier. Audio from remote site is output through
Line out in bi-directional audio mode. Use the standard stereo earphone jack for the
connection.
y Reset Button:
Factory Default Switch
There is a switch provided for returning the network camera to factory default state. Press the
switch about 3 seconds through a tiny hole at the left of the 100BaseT connector using tools
with sharp tip for a few seconds while power is applied.
7 of 47