CNB SDN2712CD User Manual
Page 23
9 / 16 Channel DVR User Guide
23
3-4-1. ALARM OUT
By selecting ALARM-OUT in the DEVICE menu, users can set-up the alarm-out in the screen
shown in figure 3.4.2.
Alarm-out mode in device
ALARM OUT Select the alarm number for applying the following settings.(out1 ~ 4)
SENSOR IN Set the alarm generation for occurrence of sensors detection event.
MOTION ON Set the alarm generation for occurrence of motion detection event.
VIDEO LOSS ON Set the alarm generation for occurrence of video loss event.
ALARM DURATION Set the alarm time duration.(1 ~ 255 seconds)
Figure 3.4.2. ALARM OUT setup screen
3-4-2. PTZ
By selecting PTZ in the DEVICE menu, users can set-up the ptz control options in the screen
shown in figure 3.4.3. Set the proper camera control data speed, number, type and ID to control
cameras correctly. To control the PTZ functions of the camera, connect the controller to the RS-
485 port.
PTZ mode in device
CH Select the channel number for applying the following settings.
NAME Select the protocol type of the camera which is the same as the one that is installed on
the site.
SPEED Select camera control data speed.(2400~19200bps supported)
ID If the camera has a specific camera ID, select the camera ID.(0~63)
E
N
G
L
I
S
H