Atech Tech SKAT-02 P - Manual (Page 17)

Operating and Safety Instructions
17
Illustration 3
7.1.1. Place the material to be cut on the machine table, take the measure the cutting
length using the measuring tape on the back fence, and clamp the work piece
(pneumatically or manually).
7.1.2. Start to operate the saw blade by pressing the Start button.
7.1.4. Carry out the cutting operation by pressing down the cutting head holding the grip.
7.1.5. After cutting off the material, bring the cutting grip to its original position, press the
Stop button. The saw blade will come to a full stop within 15 sec.
7.1.6. Release the clamps (manually or pneumatically) and take out the cut work piece.
7.1.7. The conditioner unit collects the water within the air system in a receptacle in order
to prevent damage to the pneumatic system components. Discharge this water
periodically (at the end of the working day) by pressing or opening the button under the
conditioner.
7.1.7. The manufacturer recommends to use the following oils with the conditioner: TELLUS
C 10 / BP ENERGOL HLP 10/ MOBIL DTE LIGHT / PETROL OFISI SPINDURA 10.
Don’t operate the saw while it touches the work piece. The saw must be operated only
when the head is in the top position.
Pressure
Adjustment
Button
Manometer
Oil Depot
Oil Filling Tap
Air Pressure and
Water Discharge
Screw