Comprehensive CSW-HD440EXT - Manual (Page 6)

HDMI SWITCH SPLITTER 4×4 （matrix）by Cat5
５
parameter as follow:
Baud frequency：4800
Data bit: 8
Parity bit: N
Stop bit: 1
Data stream: NON
C. Inputting your instruction. The instruction should be two or three letter, and
finish with
“Enter” button.
Please input next instruction in three seconds or the
”
Overtime instruction
”
will appear.
The input instruction should be right, or you will be rejected with the
“
wrong
instruction
”
If the input or output that you chose is not connected to devices or not in
power-on mode,
“
ineffective instruction
” will inform you.
If your instruction is performed, you can see the instruction of
“
successful
operation
”.
③. Instruction input method
A. Selecting source device
Sequence number of output (A/B/C/D) + sequence number of the input
(1/2/3/4) + “Enter”
For example: If you want display B to view source 3, then you can input “B3
“and finish with “Enter”.
B. Turning off an output
C + Sequence number of the output that you want to turn off (A/B/C/D) +
“Enter”
For example: If you want to turn off output B, then you can input CB, and
finish with
“Enter”.
C. Turning off the Switch Splitter:
OFF + “Enter”
D. Turning on the Switch Splitter:
ON + “Enter”
E. Inquiry:
QS +
“Enter”
This order enables you know which input and output are available and the
connections of input and output.