CTI Products CCU Channel Control Unit - Manual (Page 17)

CCU Hardware Reference Connectors
CTI Products, Inc.
68-11843-105
11
5. Connectors
The NETWORK IN/OUT ports on the front of the CCU are used to connect the
CCU with other MCN modules. These ports carry both the network data signals
as well as DC power for power distribution with other modules. Table 7 gives the
pinout for these connectors. Figure 5 shows the location of pin 1 for each port.
CA-80068-100
DC IN
IN OUT NETWORK
PRODUCTS, INC.
PIN 1
Figure 5 - Network IN/OUT Ports
Pin Function
1 DATA +
2 DATA -
3 + POWER
4 No Connect
5 No Connect
6 - POWER
7 - POWER
8 + POWER
Table 7 - Network Connector Pinout
The DC IN port provides the primary power connection to the module. Power is
distributed through the NETWORK OUT connector to provide power to the
NETWORK IN connector of the MCN unit it is connected to. Each power
supply can power up to four units total. See reference 1 for complete details of
connections to the network and DC IN connectors.
Connector J1 provides the discrete I/O signals. The following tables show the
pinouts in Logical and Punch-Block order. Since this module uses CIB hardware,
the old CIB functions and Hardware Pin I/O types are listed for all pins.