CTI Products TIB TSAM Interface - Manual (Page 2)

TIB TSAM Interface Module
TI B 2005-08
MCN, MCNRCD, TIB, CIB and HIB are trademarks of CTI Products, Inc.. Windows, Windows NT, 2000, XP are trademarks or registered trademarks of Microsoft.
Other trademarks referenced are properties of their respective owners. Specifications subject to change or improvement without notice.
How the System Works
The TIB module is associated with a CIB Comparator Interface
Module. (One CIB module is required per TIB module.) Each
TIB module can control up to 8 transmitters (1 TSAM unit).
The TIB module accepts TX Selected inputs from the TSAM
unit and passes the Selected TX information to the CIB
module, which then passes the information to the PC.
The TIB module accepts "Force Vote" signals from the CIB
module and sends TX Select and Force Vote signals to the
TSAM unit.
As shown above, the Operator Interfaces may be connected to
the network locally or remotely through leased-line or dial-up
modems.
Multiple TIB and TSAM Units
If a system requires more than one TSAM unit (for more than 8
transmitters), multiple TIB units are required, one per TSAM
unit.
Multiple Displays
The MCN System offers full parallel status and control at
multiple PC Operator Interfaces.
PC Displays and Console
Displays may be mixed in a single system with some
limitations.
Dial-Up Applications
For maintenance purposes, the PC display can be used over
dial-up lines. Since the PC does not have to be dedicated, it
may be used for other applications when not monitoring the
comparator.
Technicians can even diagnose after-hours
system problems from home using a properly equipped PC
and dial-up modem.
General Specifications
Size (MCN Size A): 5.5" x 4.2" x 1.5"
(140 x 107 x 38 mm)
Weight: 16 oz, (455 g)
Temperature: 0-50
o
C
Humidity: 10- 95% non-condensing
Transmitters controlled: 8 per TIB (one TSAM unit)
Logic Inputs: 8: TX Selected Indications
Logic Levels, active low
Outputs: 8: TX Select (manual select)
1: Force Select
Logic Levels, active low
Max I/O voltage: +30 VDC
Comparator Connector 50 pin Telco style, Female
Network Connectors: (2) RJ-45 (1 in, 1 out)
Max. network segment: 4000 ft. without repeaters
Max. TIB modules: 16 per network segment
(Larger, multi-segment systems
can be custom-configured.)
Network Cabling 4 Pair Level 4 UTP
Power Input 12 to 30 VDC / 2 W
Safety Approvals to: UL 1950, CSA 1950
EN60950-1992 (CE)
Emissions Compliance: FCC part 15, Class A
IC (DOC), Class A (Canada)
EN55022, Class A
Susceptibility
Compliance: IEC 801-2, 3, 4
EN50082-1
Typical TSAM Transmitter Steering System with TIB
COM 2
COM 1
CA-80118-100
P/S
OUT
T IN 1
COMPARATOR
TSAM
VOTE LINES
FORCE SELECT
TX SELECT IN
OUT T
TIB
TX1
RX1
RX8
TX8
HIB
IN
OUT
CIB
TX AUDIO
PTT
RX AUDIO
CONSOLE
LOCAL PC