Controlled Products Systems Group 1503-080 - Manual (Page 15)

Page 15
Keep a record of the programmed codes by completing the table on page 17.
2.1 Master Code
The Master Code is a four-digit number that is used to access all programming functions of the digital
keypad. The default factory master code is set to 9999. We suggest that you program a new master
code once the system is installed. After programming the master code, write it down and keep it in a
safe place. If you forget your master code, you will need to program a new one before you can
access any of the programming functions of the digital keypad.
1. Open the cabinet and locate the Master Code button on the circuit board.
2. Press the Master Code push button once.
3. Enter a four-digit code _ _ _ _ on the keypad and then press * (long beep).
4. Close the cabinet.
2.2 Relay Strike Time
The relay strike time sets the amount of time that the relay in the digital keypad remains activated
after a valid code is entered on the keypad. Setting the strike time to 00 will activate the relay for ½
second. The factory setting is 1 second.
1. Press *3 and enter the four-digit master code (short beep).
2. Enter the relay time in seconds _ _ (00 – 99) then press * (short beep).
3. Press 0# together to end the programming step (long beep).
2.3 Programming Four-digit Entry Codes
1. Press *2 and enter the four-digit master code (short beep).
2. Press 1* (beep) to enter the first four-digit entry code.
3. Enter the four-digit code _ _ _ _ then press * (beep).
(If a second code is not desired, skip steps 4 and 5).
4. Press 2* (beep) to enter the second four-digit entry code.
5. Enter the four-digit code _ _ _ _ then press * (beep).
6. Press 0# together to end the programming step (long beep).
2.4 Erasing Four-digit Entry Codes
1. Press *2 and enter the four-digit master code (short beep).
2. Press 1* (beep) to erase the first four-digit entry code.
3. Enter # # # # then press * (beep).
(If a second code is not going to be erased, skip steps 4 and 5).
4. Press 2* (beep) to erase the second four-digit entry code.
5. Enter # # # # then press * (beep).
6. Press 0# together to end the programming step (long beep).
SECTION 2 - PROGRAMMING