Chamberlain TAC1 - Manual (Page 11)

11
POWER
1 2
POWER
1 2
12 Vac
Power (included)
110 Vac Outlet
Check the Power LED
is illuminated.
PLUG THE TRANSFORMER INTO THE OUTLET
MOUNT THE UNIT
NOTE: Once power is applied, the TAC1 will begin to click to
indicate that it is powered, and is waiting to be programmed for
the unit’s Master Code. The Master Code is used to unlock the
programming functions of the TAC1. The Master Code should not
be distributed as a User Code.
NOTE: DO NOT push the
top of the unit onto the back
panel before the bottom of
the unit is in place.
1. Slide the bottom of the unit onto the back panel.
2. Gently press the top of the unit onto the back panel.
3. Lock the unit with the key.
IMPORTANT NOTE: Failure to correctly mount the unit to the back
panel may cause damage to the board.
Plug the transformer into the 110 Vac outlet.
Write down the Master Code and store in a secure location.
INSTALLATION
>> PLUG THE TRANSFORMER INTO THE OUTLET, MOUNT THE UNIT AND
SET THE UNIT MASTER CODE
8 9 7
0
2 3 1
5 6 4
SET THE UNIT MASTER CODE
NOTE: The star (*) button acts as a cancel command that will end any call, programming or access code key sequence.
Enter on the unit’s keypad.
Enter 4 digit Master Code. Example: 1234.
“BEEP” “BEEP”