Chamberlain TAC1 - Manual (Page 16)

16
PROGRAM A PRE-INSTALLED LIFTMASTER RECEIVER
ERASE ALL CONTROL CODES
Press and hold the learn button on the receiver until the indicator
light turns off indicating that the receiver memory is clear
(about 6 seconds).
When either of the relays is activated the TAC1 will emit a 315 MHz
signal to the receiver.
PROGRAMMING
>> TELEPHONE COMMANDS AND PROGRAM A PRE-INSTALLED
LIFTMASTER RECEIVER
Learn Button
Indicator Light
TRIGGER RELAY 1
Enter the command tone: 9
TRIGGER RELAY 1
Enter the command tone: 9
TRIGGER RELAY 2
Enter the command tone: 5
TRIGGER RELAY 2
Enter the command tone: 5
DISABLE “DO NOT DISTURB” MODE
CALL WAITING
Enter the command tone: 1 2
Press “Flash” once to answer guest, Once again to return to
outside call on telco line, if 9 or 5 is not
pressed. If 9 (relay 1) or 5 (relay 2) is
pressed, the TAC1 will automatically return to the telco line.
ENABLE PARTY MODE (RELAY 1)
Enter the command tone: 0 4
To disengage party mode: Enter “*9” into the local
telephone.
ENABLE “DO NOT DISTURB” MODE
Enter the command tone: 1 1
TELEPHONE COMMANDS
FROM LOCAL TELEPHONE
ACCEPT CALL FROM UNIT ON REMOTE TELEPHONE
Enter the command tone: 0
Extend talk time: “Talk” or press 0
FROM FORWARDED TELEPHONE
1. Locate the receiver. Refer to the gate or door operator manual
for information about the location of the learn button.
2. Press and release the learn button on the receiver. The
indicator light will light for 30 seconds indicating that receiver
is in Learn Mode.
3. Within 30 seconds enter Master Code on the TAC1 keypad.
4. Press “1” key on the TAC1 keypad. The indicator light on the
receiver will blink 3 times indicating programming is
successful.
NOTE: An error tone will be heard for 3 consecutive activations
only. After the third activation the unit assumes that the unit has
been replaced with the receiver.
Repeat steps 2-4 for each LiftMaster door or gate operator that
will be controlled (2 maximum).