APW Wyott BW-30 User Manual
Page 5
5
OPERATING INSTRUCTIONS
1.
If moist heat is desired, raise the bun support and place a damp towel or 4-8 ounces (118 ml - 236
ml) of water into the drawer pan.
2.
Turn the thermostat to the desired setting: the HEATING lamp will then light.
3.
When the desired temperature is reached, the HEATING lamp will go off, and the unit will maintain
the selected temperature automatically.
The bun warmer operates in a heat range of 60°F to 250°F (15.5°C to 121.1°C).
4.
The unit is now ready to use.
NOTE:
!
!
WARNING: This unit is not intended to hold potentially hazardous foods such as un-cooked or un-
preserved meats and sausages.
Once a week or more often if necessary clean the unit thoroughly. Turn off the unit and allow it to warm.
To remove normal dirt or product residue from stainless steel, use ordinary soap and
water (with or without detergent) applied with a sponge or cloth. Dry thoroughly with a clean cloth. Never
use vinegar or corrosive cleaner.
To remove grease and food splatter or condensed vapors that have baked on the equipment, apply
cleaners to a damp cloth or sponge and rub cleanser on the metal in the direction of the polished lines on the
metal. Rubbing cleanser as gently as possible in the direction of the polished lines will not mar the finish of
the stainless steel. NEVER RUB WITH A CIRCULAR MOTION. Soil and burnt deposits which do not
respond to the above procedure can usually be removed by rubbing the surface with SCOTCH-BRITE
scouring pads or STAINLESS scouring pads.
a wire brush, steel or abrasive scouring pads (except stainless), scraper, file or other steel
tools. Surfaces which are marred collect dirt more rapidly and become more difficult to clean. Marring also
increases the possibility ofcorrosive attack.
use any corrosive cleaner. Use only cleaners approved for stainless steel.
use cleaning solvents with a hydrocarbon base.
STAINLESS STEEL:
Do not use chorine based cleaners.
NEVER USE
NEVER
NEVER
!
!
WARNING: Never clean any electrical unit by immersing it in water. Turn off before cleaning
surface.
!
!
CAUTION:Do not use ordinary steel wool as any particles left on the surface will rust.
MAINTENANCE
!
!
WARNING:
-
SHOCK HAZARD
De-energize all power to equipment before cleaning the
equipment.
EQUIPMENT PREPARATION
Clean the unit before using. Wipe body and the inside of the unit with a hot, wet cloth to remove any shipping
dust or protective oil.