Controlled Products Systems Group 104572 - Manual (Page 8)

8 FAAC Model 390 24V Articulated Arm Swing Gate Operator
4.2.3. RECOMMENDED DIMENSIONS FOR OUTWARD
OPENING "overhead” swing mounting dimensions
A B C (max) α
2⅜ - 4⅜ 4⅜ - 5⅛ 28¾ 90°
4⅜ - 6¼ 4⅜ - 5⅛ 28¾ 90°
6¼ - 8¼ 4⅜ - 5⅛ 28 90°
8¼ - 10¼ 4⅜ - 5⅛ 27½ 90°
10¼ - 12¼ 4⅜ - 5⅛ 27⅛ 90°
12¼ - 14⅛ 4⅜ - 5⅛ 26⅜ 90°
2⅜ - 4⅜ 7½ - 8¼ 23½ 120°
4⅜ - 6¼ 9 - 9⅞ 22 120°
6¼ - 8¼ 11⅜ - 12¼ 19 120°
8¼ - 10¼ 12¼ - 13 17¼ 120°
SX DX
SX DX
Fig. 8
Fig. 9
Fig. 10
Establish the installation position of the operator by consulting
Figs. 4-6.
4.3. INSTALLATION STEPS
The operator 390, base-plate and articulated arm are designed
either for right-hand or left-hand (Fig. 7) installation.
• Secure the base-plate to the pilaster, using Ø10 screws
and suitable expansion plugs (Fig. 8), and ensure that it is
perfectly horizontal.
• Fit the gearmotor unit on the base-plate and secure it with
the two screws, nuts and flexible washers (Fig.8).
• The transmission shaft must always face downward.
• Assemble the articulated arm and front coupling as
shown in Fig. 9.
• Fit the straight lever of the articulated arm on the gear-
motor shaft and tighten it with the supplied screw and
washer (Fig. 10).
• Release the operator (See Chapter 5)
DX SX
SX
DX
Fig. 7
Fig. 6a
• Measurements in Inches
• Establish the securing position of the front coupling on the
leaf, observing dimension “C” defined previously (Section
4.2). Check that arm and coupling are perfectly horizontal.
• The coupling may be welded directly onto the leaf (Fig. 11)
or screwed by using the threaded inserts (Fig. 12).
• In both cases, temporarily remove the coupling from the
arm in order to secure it.
• Fit the cover on the operator (Fig. 10).
• Re-lock the operator (See Chapter 5)
• Make the electrical connections of the selected electronic
appliance, observing the annexed instructions.