Controlled Products Systems Group 9100-080 - Manual (Page 15)

9100-065-Z-3-13 13
• Set one chain Idler wheel at the top and one in the
center position on one side of the operator.
• Remove both chain knockouts from one side of the
operator.
• Chain stops or gate end retainer can be
used as the physical stop for the gate
(Chain stops are shown).
Additional hardware required. Endless idler assembly (P/N 2600-818) and
additional chain #40 (P/N 2600-442 - 20 ft. per box) may be needed.
Additional hardware required. Post base plate (P/N 2600-418) 4 x 4 steel posts not available from DoorKing.
Rear Position with Concrete Pad
Hides the chain from outside the property looking in.
• Chain setup is the same as above.
Rear Position with Post Mount
Hides the chain from outside the property looking in.
Chain Idler
Wheels
Chain
Stop
Chain Setup
Top View
A filler post or barrier may need to be
installed between the gate and wall area
(See page 4 for more information).
See page 18 for
more information
about endless idlers.
Endless
Idler