Controlled Products Systems Group LA500 - Manual (Page 16)

14
DETERMINE THE POSITION OF THE GATE BRACKET + WELD THE BRACKETS
INSTALLATION
DETERMINE THE POSITION OF THE GATE BRACKET
WELD THE BRACKETS
1
Position the operator on the brackets and make sure the operator is level and
positioned correctly on the gate.
2
Remove the operator from the gate.
3
Completely weld around the post bracket and gate bracket.
The gate bracket MUST be installed in an area that can withstand heavy forces.
Additional reinforcement steel plates may be necessary for mounting.
1
Position a level on the post bracket and measure 27.75 inches over from the
center of the gate hinge point and mark the location on the gate.
2
Measure 2.25 inches down from the previous mark and center the bracket on
this mark. Tack weld the gate bracket in this position.
27.75"
2.25"
Gate Bracket Location
Gate Hinge Point