Controlled Products Systems Group 318N - Manual (Page 3)

EN
English - 1
Original instructions
ENGLISH
1 – PRODUCT DESCRIPTION AND
INTENDED USE
This receiver is part of the “Flor” series by Nice spa. This
series of receivers is intended for use on the Control units
featured in automated systems for gates, garage doors and
road barriers. Any other use is to be considered incorrect
and forbidden! The manufacturer shall not be held liable
for damage due to improper use of the product other
than that specified in this manual.
2 – PRODUCT TECHNICAL
SPECIFICATIONS
• For all models
– The receiver handles “Flor” type radio encoding with a
variable code (rolling-code) and also recognises the C-
Code encoding of the Opera series for the basic functions.
– These models have 1 or 2 relays with clean contact output;
they can therefore be used with any type of Control unit.
3 – PRODUCT INSTALLATION
• For models with “NICE” connector
These models are connected to the Control system by
inserting their connector into the specific one featured on the
Control unit. Important! – Before connecting or removing
the receiver, cut off the electricity supply to the Control
unit.
In addition, you should install the aerial provided, connecting
it to the purpose-provided terminals on the Control unit.
WARNINGS
WORKING IN SAFETY!
CAUTION! – For personal safety it is important to
observe these instructions.
CAUTION! – Warning - Important safety instructions:
keep these instructions in a safe place.
CAUTION! – All product installation, connection,
programming and maintenance operations must be
performed exclusively by a qualified and skilled te -
chnician.
Observe the following warnings:
– Never make any modifications to part of the product
other than those specified in this manual. Unautho-
rised operations can be the source of hazards and
malfunctions. The manufacturer declines all liability for
damage caused by makeshift modifications to the
product.
– Keep this manual in a safe place to enable future product
maintenance and programming operations.
– The product packaging material must be disposed of in full
ob servance of current local legislation governing waste
disposal.