Chamberlain 371LM - Manual (Page 2)

© 2009, The Chamberlain Group, Inc.
114A4109 All Rights Reserved
REPLACEMENT PARTS
3V2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor Clip (not available for mini-remote controls). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
Premium Remote Control Only
3V2016 Lithium battery: LED and Opener (2 required) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A19
3V2450 Lithium battery: Proximity Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A33
Visor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29C151
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first retail purchaser of this product that is free from
defect in materials and/or workmanship for a period of 1 year from the date of purchase.
3-BUTTON REMOTE CONTROLS
Additional buttons on any Security✚ ® remote
control or mini-remote control can be
programmed to operate other Security✚
®
garage door openers, light controls, gate
operators or access control systems.
HOW TO USE THE REMOTE CONTROL
Press and hold the button down until the door or gate
starts to move. The remote control will operate the garage
door up to 3 car lengths away on typical installations.
Installations and conditions vary, contact an installing
dealer for more information.
PREMIUM REMOTE CONTROL ONLY
The premium remote controls are equipped with a proximity lighting
feature. When a hand moves within close proximity to the remote
control, the LED lights turn on for 3 seconds. Upon successful
activation of a remote control button, the LED lights will blink rapidly.
To conserve battery life the proximity lighting feature may be disabled.
The remote control will turn off the proximity lighting feature if the
proximity lighting is turned on 10 consecutive times without activation
of a button. To re-enable the proximity lighting, simply press a button.
PROBLEM SOLUTION
LEDs are erratic, dim or
not illuminated when a
hand comes within
close proximity Press one of the buttons on the hand-held remote control.
Sit remote control undisturbed for 60 seconds on a non-metallic
surface. This allows the sensor to recalibrate itself.
Replace proximity battery with same type coin cell (3V2450).
Dim LED lights - OR -
No rapid LED blinking
after pressing a button
Replace two batteries with same type coin cells (3V2016).
The proximity sensor
will not work If the spring contact inside the remote is bent the proximity sensor
will not work.
Troubleshooting
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment
or modifications of this receiver and/or transmitter are prohibited, except for
changing the code setting or replacing the battery. THERE ARE
NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V2032 coin batteries.
• Replace ONLY with 3V2016 or 3V2450 coin batteries.
• DO NOT recharge, disassemble, heat above 212°F
(100°C) or incinerate.
1 2 3 4
3V2032
Use the visor clip or
screwdriver to pry open
the cover. Remove the old battery.
Dispose of old batteries
properly. Insert replacement
batteries positive side up.
Replace the batteries
with only 3V2032
coin cell
batteries. Replace cover.
1
Remove the two screws
and open the remote
control housing.
2
Slide the old batteries out.
Dispose of old batteries
properly.
3
Insert replacement
batteries positive side up.
Replace the batteries with
only 3V2016 or 3V2450
coin cell
batteries.
4
Replace screws.
3V2016
3V2450
THE REMOTE CONTROL BATTERY
The lithium battery should
produce power for up to 5 years.
To replace battery:
The 3V2016 lithium batteries for
the opener and LEDs (marked
“LED and Opener Battery”) should
last up to 5 years. The 3V2450
lithium battery for the proximity
lighting (marked “Proximity
Battery”) should last 1-2 years.
To replace the batteries:
Premium Remote Control Only