Controlled Products Systems Group 1838-080 - Manual (Page 26)

1838-065-G-12-06
STOP!!
If the access control system is to be programmed from a PC, no other programming is required at the
system itself. Refer to the Remote Account Manager for Windows software manual for additional
programming information. Continue with the remaining sections in this chapter if the system will be
programmed from the keypad. If the factory setting matches your need, there is no reason to
reprogram that section. Remember that relay hold open time zones, security levels, and elevator
control functions can only be programmed from the Remote Account Manager software. If any of
these features are being used, do not proceed with any other programming steps in this manual.
Page 26