American DJ Utopia 250S User Manual
Page 3
©
American DJ
®
- www.americandj.com - Utopia 250S™ Instruction Manual Page 6
©
American DJ
®
- www.americandj.com - Utopia 250S™ Instruction Manual Page 5
Utopia 250S™
Controls and Functions
REAR
FRONT
2
8
9
10
5
4
ON
1 2 3 4
ON
1 2 3 4 5 6 7 8 9
11
3
1
7
6
7
14
15
1
13
12
1.
Thumb Screw - This thumb screw holds the lamp socket assembly
cover (16) into place.
2.
Microphone - This microphone receives external low frequencies
to trigger the unit in Sound-Active and Master/Slave mode.
3.
Audio Sensitivity Knob - This adjust audio sensitivity of the
internal microphone (3). Turning the sensitivity knob in the clockwise
direction will increase the sensitivity to sound. Turning the knob in
the counter clockwise direction will decrease the fi xture’s sensitivity
to sound.
4.
Option Switches - These switches will activate one of four
options:
Switch 1: Focus - When activated this switch will center the mirror
with a white spot. This will allow you to focus the beam
properly.
Switch 2: Sound Active - Turning this switch to the on position will
activate sound-active mode.
Switch 3: Inverted Pan - When activated this switch will invert the
PAN value. Left will become right and vice versa.
Switch 4: Inverted Tilt - When activated this switch will invert the
TILT value. Up will become down and vice versa.
5.
Dip Switches - These switches serve two functions. In master
slave mode these switches are used to assign a specifi c head
address. In DMX mode these switches are used to assign a DMX
address to the unit. In DMX mode each switch corresponds to a
specifi c value based on binary code. See page 7 for a detailed
explanation of DMX binary code.
6.
Power Indicator - This light will fl ash when the unit is in use.
7.
Utopia/C Controller Jack - This jack is for use with the optional
Utopia/C Blackout controller only. Do not attempt to connect an audio
signal this jack, this will damage the PC board and void your manufac-
tures warranty!
8.
XLR Input Jack - This jack is used to accept an incoming DMX
signal or Master/Slave signal.
9.
XLR Output Jack - This jack is used to transmit the incoming
Utopia 250S™
Controls and Functions