Controlled Products Systems Group 0-205679 - Manual (Page 64)

4.2.2.E Programming Card ONLY Use
Card ONLY use can be programmed with command
50. The programming sequence is as follows:
50 # user-type # user location # **
<present card>
4.2.2.F Programming Code OR Card
Finally, you can program a user for either Code OR
Card use as follows:
52 # user-type # user location # keypad
PIN* keypad PIN * <present card>
Chapter 4: Programming 4.2 Programming Users
4-12 prox.pad plus Install/Program. Manual, PPP, D4b
Part No. 6105679, Rev. 1.1