AT&T 8410 - Manual (Page 32)

32 Issue 1 March 1996
Select Ringing Pattern 0
You can select one of eight different ringing patterns for incoming calls. When
there are several users in the same seating area, you can select a distinct ring-
ing pattern so you can recognize when your voice terminal is ringing.
To select a ringing pattern, do the following:
1. While on-hook, press , and then press .
■ The current ringing pattern rings repeatedly.
■ The lamp flashes.
■ The display shows the current ringing pattern number:
2. Press repeatedly to step through the rest of the ringing patterns.
3. When you hear the ringing pattern you want to use, press .
■ You hear two beeps which indicates that the change was
accepted.
Self-Test 0
To test the lamps on your voice terminal, do the following:
1. Press and hold .
■ The lamps on the left side go on followed by the lamps on the right
side.
2. Release to end the test.
■ All the lamps go off, except for the lamp, which stays green
for a few seconds.
Shift Hold
Shift
SELECT RING PATTERN: 3
Hold
Shift
Test
Test
Test