L-com HG5328D - Manual (Page 2)

IP-00033 Rev. C – 06/05 Page 1/1
1. Attach antenna feed horn to dish using included
hardware (see below).
2. Attach Mounting Bracket to mast using included
U-Bolts and hardware. For up-tilt installations the
tilt adjustment arm should be on the bottom
(as shown). For down-tilt installations the tilt
adjustment arm should on top.
3. Attach dish antenna to mounting bracket as shown.
Adjust antenna to desired tilt and lock into place using
nuts on the tilt adjustment arm.
Tilt Adjustment Arm
Mounting Bracket
Feed Horn
Dish
Installation Instructions
Models: HG5328D, HG5829D, HG5833D
HG5428D, HG5432D
Rear View
Installation Note: The Feed Horn can be oriented
for either vertical or horizontal polarization. A small
arrow on the tip of the feed horn indicates direction.
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845
WWW.L-COM.COM E-MAIL: [email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com logo are registered marks.