Specifications and features – Lectrosonics UM400a User Manual

Page 16

Advertising
background image

UM400a

LECTROSONICS, INC.

16

Operating frequencies:

Block 470: 470.100 - 495.600

Block 19: 486.400 - 511.900

Block 20: 512.000 - 537.500

Block 21. 537.600 - 563.100

Block 22. 563.200 - 588.700

Block 23. 588.800 - 607.90. an. 614.100 - 614.300

Block 24. 614.400 - 639.900

Block 25. 640.000 - 665.500

Block 26. 665.600 - 691.100

Block 27: 691.200 - 716.700 (export only)

Block 28. 716.800 - 742.300 (export only)

Block 29. 742.400 - 767.900 (export only)

Block 944: 944.100 - 951.900

Frequency selection:

256 frequencies in 100kHz steps

RF Power output:

100 mW (nominal)

Pilot tone:

25 to 32 kHz frequency; 5kHz deviation

Frequency stability:

± 0.002%

Deviation:

± 75 kHz (max)

Spurious radiation:

90 dB below carrier

Equivalent input noise:

–120 dBV, A-weighted

Input level:

Nominal 2 mV to 300 mV, before limiting.

Greater than 1V maximum, with limiting.

Input impedance:

Dynamic mic:

300 Ohms

Electret lavaliere:

Input is virtual ground with servo adjusted constant current bias

Line level:

2.7 k Ohms

Input compressor:

Dual envelope compressor, >30 dB range

Gain control range:

43 dB; semi-log rotary control

Modulation indicators:

Dual bicolor LEDs indicate modulatio. of -20, -10, 0, +10 dB

referenced to full modulation.

Low frequency roll-off:

–18 dB/octave; 35Hz to 150Hz

Audio frequency response (overall system):

35 Hz to 20 kHz, +/-1 dB (The low frequency

roll-off is adjustable - see graph)

30

100

1kHz

10k

20k

+6

+3

0dB

-3

-6

-9

-12

Line in

Mic in 150 Hz

Roll-off

Mic in 35 Hz

Roll-off

Controls:

2 position “OFF-ON” slide switch for noiseless turn on/turn off operation.

Front panel knob adjusts audio gain. Recessed control on side panel adjusts low

frequency rolloff. Rotary switches on side panel adjust transmitter frequency.

Audio Input Jack:

Switchcraft 5 pin locking (TA5F)

Antenna:

Detachable, flexible wire supplied. 50 Ohm port allows connection to test equipment.

Power Consumption:

80mA

Battery:

Precision compartment auto-adjusts to accept any known alkaline 9 Volt battery.

Battery Life:

5 hours (alkaline); 10 hours (lithium)

Operating Temperature:

-20 to +140 degrees F

Weight:

6.3 ozs. including battery

Dimensions:

3.1 x 2.4 x .75 inches

Emission Designator. 180KF3E

Specifications subject to change without notice.

The FCC requires that the following statement be included in this manual:
This device complies with FCC radiation exposure limits as set forth for an uncontrolled environment.

This device should be installed and operated so that its antenna(s) are not co-located or operating in

conjunction with any other antenna or transmitter.

Specifications and Features

Advertising