Lectrosonics Venue Series (Wideband) - Manual (Page 11)

Digital Hybrid Wireless™ Modular Receiver System
Rio Rancho, NM, USA 11
Navigating the LCD Menus
and Screens
Front panel controls provide access to screens and
menus for setup. The Function Button, Back Button, Re-
ceiver Select buttons and the MENU/SELECT control
are used to make selections and adjust parameters.
Function Button (labeled by the LCD)
Back Button Receiver Select
Buttons 1-6
MENU/SELECT
Control
The overview screen displays a summary of all six
channels, as shown above. This is a good starting point
for navigating to any menu or setup screen. Pressing
the BACK button repeatedly from any menu or screen
will eventually return to this overview screen.
From the overview screen, pressing one of the six
Receiver Select Buttons will switch to the detail screen
for the associated receiver module to display all current
settings, levels and status.
Receiver Module
Location
Pilot Tone
Monitoring Status
Operating
Frequency
RF Signal
Strength
Antenna Phase
Transmitter
Battery Gauge TV Channel
Audio Level Meter
Tuning Mode
Transmitter Frequency
Select Switch Settings
Pressing the Receiver Select Button again will switch
to the receiver module information screen to show the
basic setup.
Press the BACK button twice to return to the overview
screen.
From the overview screen, press the MENU/SELECT
control to open the TopMenu, rotate the control to
select an item, then press the control to enter the setup
screen for that item.
In a setup screen such as the LockSet example shown
here, up/down arrows prompt you to change the setting
by rotating the MENU/SELECT control.
Up/Down
Arrows
When the desired setting or value is displayed, press
the MENU/SELECT control or BACK button to return to
the previous menu.
Selecting SetUpRx (set up receiver) in the TopMenu
will take you to another menu where all settings for the
receiver modules can be made.
Select an item with the MENU/SELECT control and
press the control to open the setup screen (“Level” in
this example).
Setup screens for the receiver modules display the
settings for the selected module and allow immediate
access to all modules by pressing the Receiver Select
Buttons. Receiver module 1 (Rx1) is selected in this
example with its output level set at -3 dBu.
Function
Button
If another option is available, it will appear in the left
hand section of the LCD (“TONE” in this example).
Press the Function Button to select and deselect this
option with repeated presses. The display will highlight
the option when it is selected.
NOTE: Settings take effect immediately and are
stored until changed again. Pilot Tone Bypass is
different in that it resets to the default value when
the power is cycled.