Rear panel controls and functions – Lectrosonics DR175NC User Manual
Page 4
REAR PANEL CONTROLS AND FUNCTIONS
ANTENNA INPUTS These inputs connect to any 50 ohm antenna with a BNC type connector.
12 VDC IN This input connects to the supplied CH-12 AC adapter for powering the receiver from a 110/120V AC
source. The receiver may also be powered from external 12 volt DC sources using the correct plug (Switchcraft
S-760 power plug). The center pin is positive. (+).
AUDIO OUT
This XLR type connector supplies a balanced, low impedance output at microphone level. The audio signal is
present on pins 2 and 3, while pin 1 is ground. The output level of this jack is controlled by the AUDIO LEVEL
control on the front panel of the receiver. Pin 2 is "hot" in terms of polarity.
ANT B
ANT A
AUDIO OUT
12V DC IN
PATENT
PENDING
1
2
3
Figure 2 - DR175 Rear Panel
4