Lectrosonics UDR200c - Manual (Page 11)

11
Wireless Diversity Receiver
Rio Rancho, NM – USA
Frequency and Battery Voltage
6 6 8 . 1 0 0 8 . 7 V 1 9
In this mode, the frequency in MHz is displayed on the left side
of the display and the hexadecimal transmitter channel code is
displayed on the right. Whenever valid transmitter battery
voltage information is available, it is displayed in the center. A
stable, moderately strong signal must be maintained for at
least 30 seconds in order to get a good battery voltage indica-
tion.
Tuning controls operate as described under Tuning Modes,
above.
Frequency and TV Channel
6 6 8 . 1 0 0 T V 4 7 1 9
In this mode, the frequency in MHz is displayed on the left side
of the display and the hexadecimal transmitter channel code is
displayed on the right. In the center is the UHF TV channel
associated with this frequency. On UDR200C models, U.S. TV
channels are shown, and on UDR300C models, European TV
channels are used.
Tuning controls operate as described under Tuning Modes,
above.
Frequency Name
L E C T R O 1 1 9
In this mode, the frequency name (from the active group) is
displayed along with the hexadecimal transmitter channel
code. If the current channel has no name associated with it in
the active group, the display looks like this.
G R P 1 S E L E C T 2 0
Tuning controls operate as described under Tuning Modes,
above.
Active Group and Lock Status
G R O U P 1 : U N L O C K E D
G R O U P 1 : L O C K E D
G R O U P 1 : H R D L O C K
This mode permits selection of the active group and adjust-
ment of the receiver’s lock status. Use the UP and DOWN
buttons to browse among the four possible active group set-
tings.
The lock status has three possible settings, Unlocked,
Locked, and Hard Locked. The normal setting is Unlocked,
which permits full control of the receiver from the front panel.
In the Locked or Hard Locked states, the MENU key can still
change between the four display modes, but the UP and
DOWN buttons cannot tune the receiver or otherwise alter any
settings. The difference between the Locked and Hard Locked
states is that a Hard Locked receiver can only be unlocked
with a special power-up button sequence or with the
UDRpanel software. A receiver that is merely Locked can be
unlocked from the front panel.
Receivers may be freely toggled between the Locked and
Unlocked states in this operating mode. To lock, hold down
the MENU key and press the UP button. To unlock, hold down
the MENU key and press the DOWN button.