Lectrosonics UT195 - Manual (Page 11)

SPECIFICATIONS AND FEATURES
Receiver
Operating Frequencies:
Receiver Type:
Frequency Stability:
Front end selectivity:
IF Selectivity:
IF Frequency:
IF bandwidth:
Sensitivity
20 dB Sinad:
60 dB Quieting:
Squelch quieting:
AM rejection:
Modulation acceptance:
Image and spurious
rejection:
Third order intercept:
FM Detector:
Antenna input:
Audio outputs
Rear Panel XLR:
Monitor out:
Front Panel Controls
and Indicators:
Rear Panel
Connectors:
Rear Switch:
Power Options:
Weight:
Dimensions:
470 to 608 MHz, crystal controlled
Dual conversion, superheterodyne
±0.002 %
-22 dB at ±4 MHz
>90 dB at ±300 kHz (10.7 IF)
10.7 MHz (1st IF); 455 kHz (2nd IF)
±150 kHz at ½ power points
0.63 uV (-111 dBm), A weighted
1.0 uV (-107 dBm), A weighted
Greater than 125 dB
Greater than 60 dB, 2uV to 1 Volt
(Undetectable after processing)
±75 kHz
> 98 dB
–5 dBm
Digital Pulse Counting Detector
BNC female; 50 Ohm impedance
Nominal 600 Ohm Balanced
VAR: Variable –50 dBm to –30
dBm; FIXED: +8 dBm line level
Front panel 3.5mm stereo mini jack
– high level output for stereo or
mono phones @ 32 Ohms or higher
– can be used as a high quality
audio output.
Power on/off switch and LED; Dual
function 10 segment LED level
display; Pilot tone indicator;
Monitor output jack and Level
control
XLR audio output jack;
External 12VDC input
Audio Output Range:
VAR/FIXED
12V DC, 1.7 Watts (140 mA)
16 ozs. (with batteries)
3.2” wide x 1.22” high x 5.1” deep
System (UR195 receiver with UM195 transmitter)
Audio Processor:
Total Harmonic Distortion
1 kHz:
30 Hz to 20 kHz:
Signal/Noise ratio:
Frequency Response:
Dual band compandor with no
pre-emphasis/de-emphasis
< 0.45% (60 kHz deviation)
< 1% (30 kHz deviation)
60 dB, at 0.63 uV (-111 dBm)
signal input, A-weighted
109 dB for full quieting, A
weighted
±1 dB, 30 Hz to 21 kHz,
400 Hz reference, 30 kHz
deviation
Rio Rancho, NM – USA 11