Lectrosonics Octopack - Manual (Page 9)

Receiver Multicoupler
Rio Rancho, NM 9
Receiver Removal
Disconnect all four mounting screws on
each receiver from the Octopack panel
A handy tool, constructed of Delrin, is provided to aid
in removing the receivers and to loosen overly tight-
ened coaxial connectors.
The supplied tool is stored in a clip on the battery panel
It is difficult to remove the receivers by hand due to the
friction in the 25-pin connector in the slot and the dif-
ficulty of gripping the receiver housing. The flat end of
the tool is used to remove the receivers by prying the
housing upward in the notch next to the slot.
DO NOT remove the receivers by pulling on the
antennas since the antennas and/or connectors
can be damaged.
Pry the receiver housing upward in the notch to release
the 25-pin connector
Normally the hex nuts on the coaxial RF leads are
secured and removed by hand. The tool is provided if
the nuts cannot be removed by hand.
DO NOT overtighten the nuts with the wrench.
The open end wrench is used to loosen coaxial
connector nuts that have been overtightened.