Lectrosonics MM200 - Manual - Manual (Page 2)

TABLE OF CONTENTS
INTRODUCTION ................................................................................................... 3
GENERAL TECHNICAL DESCRIPTION ............................................................. 3
CONTROLS AND FUNCTIONS ........................................................................... 6
BATTERY INSTALLATION .................................................................................... 8
OPERATING INSTRUCTIONS ............................................................................. 8
OPERATING NOTES ............................................................................................. 8
ADJUSTING THE TRANSMITTER FREQUENCY .............................................. 9
MICROPHONE RF Bypassing .............................................................................. 9
TROUBLESHOOTING ......................................................................................... 10
SPECIFICATIONS AND FEATURES ................................................................. 11
SERVICE AND REPAIR ...................................................................................... 12
RETURNING UNITS FOR REPAIR .................................................................... 12
WARRANTY ........................................................................................... Back cover
The MM200 transmitter is FCC type accepted under Part 74: 536-608 MHz and 614-806 MHz
WARNING! TO PREVENT INTERNAL CORROSION!
If the transmitter is wet (either due to immersion or high levels of perspiration),
BEFORE opening any covers or connectors, carefully blot the transmitter dry with
a clean paper towel or cloth. Remove all moisture. After opening any connector
or cover, carefully blot up any remaining moisture that may have remained around
the seal. THIS IS IMPORTANT! DO NOT CLOSE ANY COVER OR CONNEC­
TOR BEFORE MAKING CERTAIN THERE IS NO MOISTURE IN OR NEAR
THE OPENING. After use, it is important to store the transmitter in a dry place
with all access doors and connectors opened to allow any internal humidity to
evaporate. Specifically, open the battery door, the frequency cover plate and fully
unscrew and remove the microphone connector before storing. Do NOT store wet
and do NOT store sealed. If moisture is sealed inside the unit it has nowhere to go
other than to chemically react with and destroy components and the printed circuit
board.
2