Lectrosonics UH200c - Manual (Page 9)

Frequency Agile Plug-on UHF Transmitter
SERVICE AND REPAIR
If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair.
Make sure you have followed the setup procedure and operating instructions. Check out the interconnecting cords and then go
through the TROUBLE SHOOTING section in the manual
We strongly recommend that you do not try to repair the equipment yourself and do not have the local repair shop attempt
anything other than the simplest repair. If the repair is more complicated than a broken wire or loose connection, send the unit to
the factory for repair and service. Don’t attempt to adjust any controls inside the units. Once set at the factory, the various controls
and trimmers do not drift with age or vibration and never require readjustment. There are no adjustments inside that will make
a malfunctioning unit start working.
LECTROSONICS’ service department is equipped and staffed to quickly repair your equipment. In warranty repairs are made at no
charge in accordance with the terms of the warranty. Out of warranty repairs are charged at a modest flat rate plus parts and
shipping. Since it takes almost as much time and effort to determine what is wrong as it does to make the repair, there is a charge
for an exact quotation. We will be happy to quote approximate charges by phone for out of warranty repairs.
RETURNING UNITS FOR REPAIR
You will save yourself time and trouble if you will follow the steps below:
A. DO NOT return equipment to the factory for repair without first contacting us by letter or by phone. We need to know the nature
of the problem, the model number and the serial number of the equipment. We also need a phone number where you can be
reached 8 am to 4 pm (Mountain Standard Time).
B. After receiving your request, we will issue you a return authorization number (R.A.). This number will help speed your repair
through our receiving and repair departments. The return authorization number must be clearly shown on the outside of the
shipping container.
C. Pack the equipment carefully and ship to us, shipping costs prepaid. If necessary, we can provide you with the proper packing
materials. UPS is usually the best way to ship the units. Heavy units should be “double-boxed” for safe transport.
D. We also strongly recommend that you insure the equipment, since we cannot be responsible for loss of or damage to equipment
that you ship. Of course, we insure the equipment when we ship it back to you.
Mailing address:
Lectrosonics, Inc.
PO Box 15900
Rio Rancho, NM 87174
USA Shipping address:
Lectrosonics, Inc.
581 Laser Rd.
Rio Rancho, NM 87124
USA Telephones:
Regular:
(505) 892-4501
Toll Free (800) 821-1121
FAX: (505) 892-6243
World Wide Web: http://www.lectrosonics.com Email: [email protected]
Rio Rancho, NM – USA 9