Lectrosonics UM110 - Manual (Page 14)

SPECIFICATIONS AND FEATURES
Operating frequencies: 525.000 to 862.000 MHz
Frequency selection: Up to 256 frequencies
Channel spacing: 100kHz (25kHz programmable)
RF Power output: 50 mW (nominal)
Frequency stability: +/- 0.001%
Deviation: +/- 20 kHz typ., +/- 50kHz max
Spurious radiation: 90 dB below carrier
Equivalent input noise: -126 dBV
Input level: Nominal 2 mV to 300 mV, before limiting.
Greater than 3V maximum, with limiting.
Input impedance: Taps provided for 200, 1k, 10k Ohm
Input compressor: Soft compressor, >30 dB range
Gain control range: 43 dB; semi-log rotary control
Modulation indicators: Dual LEDs indicate modulation level 20dB below
limiting and at the onset of limiting.
Low frequency roll-off
adjustment: -18 dB/octave; 35Hz to 150Hz
Controls: 2 position "OFF-ON" slide switch for noiseless turn on/turn off operation.
Front panel knob adjusts audio gain. Recessed control on side panel adjusts low
frequency rolloff. Rotary switches on side panel adjust transmitter frequency.
Audio Input Jack: Switchcraft 5 pin locking (TA5F)
Antenna: Fixed, flexible cable.
Battery: Precision compartment auto-adjusts to accept any known alkaline 9 Volt battery.
(We've tried 125 different ones!)
Battery Life: 7 hours (alkaline); 14 hours (lithium)
Weight: 6.3 ozs. including battery
Dimensions: 3.1 x 2.4 x .75 inches
Specifications subject to change without notice.
This product meets the CE Compliance Standards - ETS 300 445; January
1996 and I ETS 300 422 (December 1995). A copy of the Declaration of
Conformity may be requested from your dealer or by contacting the factory
directly:
Lectrosonics, Inc.
Marketing Department
581 Laser Rd. NE, Rio Rancho, NM 87124 USA
tel: 505-892-4501 fax: 505-892-6243 e-mail: [email protected]
14