Lectrosonics UM700 - Manual (Page 10)

UM700
MICROPHONE CORD TERMINATION
1
2 3
4
5
VIEW FROM SOLDER
SIDE OF PINS
0.3"
0.15" Heatshrink
Tubing
TA5F Connector Assembly
Mic Cord Stripping Instructions
Be sure the shield wire touches the metal crimp
tab. This helps prevent any AM component of the
transmitter signal from entering the mic and
causing a "whine."
Note that this is opposite from our VHF
transmitter wiring where the shield should not
touch any metal part of the housing.
Shield Wire
Crimp
Tabs
Rubber
Insulation Crimp
Tabs Rubber
Insulation
This is the correct way. Don't do it this way!
LECTROSONICS, INC. 10