Lectrosonics VI24 - Manual (Page 2)

INTRODUCTION
The VI24 Video Switcher Interface offers flexible automated control of video switch­
ers based on the output status of up to eight Lectrosonics AM8 or AM16 mixers.
While its 24 independent logic outputs could be used to control almost anything, the
VI24 is intended primarily for use as a low-cost video-follows-audio system. Some
possible applications are:
• courtrooms
• board rooms
• panel discussions
• legislative sessions
• security systems
Using the accompanying software, you need only describe your mixer setup and
then assign mixer input activity to trigger the VI24’s logic outputs. Your settings are
then sent to the VI24 and the unit is thus “programmed” for your specific needs.
TABLE OF CONTENTS
INTRODUCTION .................................................................................................. 2
FCC PART 15 NOTICE ........................................................................................ 3
FRONT PANEL CONTROLS AND FUNCTIONS ................................................ 3
REAR PANEL CONTROLS AND FUNCTIONS .................................................. 4
INSTALLING THE SOFTWARE ........................................................................... 4
INSTALLING THE HARDWARE ........................................................................... 5
SETTING UP THE VI24 ....................................................................................... 6
SETTING UP THE VI24 FOR THE FIRST TIME ................................................. 9
TROUBLESHOOTING ....................................................................................... 11
ACCESSORIES .................................................................................................. 11
SERIAL CABLE WIRING DIAGRAM ................................................................ 12
AMX CABLE WIRING DIAGRAM ...................................................................... 12
AMX Programming Notes ............................................................................. 12
SERIAL PORT COMMANDS AVAILABLE ........................................................ 13
SPECIFICATIONS .............................................................................................. 14
SERVICE AND REPAIR ..................................................................................... 15
RETURNING UNITS FOR REPAIR ................................................................... 15
WARRANTY ......................................................................................... Back cover
2