Lectrosonics SPN812 - Manual (Page 21)

Installation and Startup Guide
Rio Rancho, NM 21
Stacking Multiple Units
If Slave units are not powered up when the Master unit
boots up, the Slave may not be detected for several
minutes. It is good practice to turn all units on simul-
taneously or turn on Slave units before turning on the
Master unit.
The available processors will appear in a “stack” on the
left side of the control panel. The Master unit will appear
at the top of the stack, with Slave units below it appear-
ing in the order that they are connected with the cable
connections to the ASPEN port jacks.
List of connected units
Refer to the cabling diagram for the ASPEN ports in the
section entitled Hardware Installation.
Refer to the Help Files
Once the processors are installed, configured and com-
municating with a computer system, refer to the Help
files in the software GUI for additional information re-
garding the available settings, adjustments and control.