Lectrosonics HM142V - Manual

HM142V
HM142V
TECHNICAL DATA
Headset Microphones
Feature Highlights
• Worn over the head or around the neck
• Omni-directional element & adjustable mic
boom for maximum gain and minimum wind
noise
• Adjustable headband cushions
• Built in volume control
• Rugged construction for long life
The HM142V headset microphones are a lightweight
design for use with a wide variety of Lectrosonics wire­
less PA, microphone and IFB systems. The stainless steel
headband and boom are adjustable for maximum comfort
and flexibility.
The foam temple pads are attached to machined alumi­
num assemblies clamped to the headband. The position
of the temple pad opposite the mic boom is adjustable for
a comfortable, secure fit. The stainless steel headbands
are simply shaped by hand to fit the head.
The pickup capsule is an omnidirectional electret type,
powered by a DC bias present on the input jack of Lec­
trosonics transmitters. The omni-directional capsule
provides a wide, flat frequency response, plus ultra low
wind noise and clothing “rattle.”
The stainless steel microphone boom is mounted in a ball
joint to allow adjustment to position the microphone to the
left and slightly away from the mouth.
The volume control on the temple pad is used to temporar­
ily control feedback when used with a sound system.
Available with a locking micro plug, TA5F 5-pin plug, or
standard 3.5mm mini plug for use with Lectrosonics wire­
less transmitters.
Rugged machined aluminum and stainless steel are used
to construct the headset for years of heavy use.
Rio Rancho, NM, USA
www.lectrosonics.com