Liquid Controls SP2850 (MS-649) - Manual (Page 21)

Sponsler, Inc. Model SP2850-TC with MS649 Page 21 DOC#: MN-2850
D 600
↓
D 1200
↓
D 2400
↓
D 4800
↓
D 9600
↓ (Press D to go to 300 ↓)
ENT PARITY (Flashes, then last parity used)
D EVEN
↓
D ODD
↓
D MARK
↓
D SPACE
↓ (Press D to go to EVEN ↓)
ENT RUN MODE
*Unit should always be `SER’, `PL’ is disabled.
STEP 9: Setting the Analog Output
Press Display
D MENU Flashes then PRESET
↓
D until ALG OUT
↓
ENT ANLG RT (Analog Output for Rate)
D (Press D to toggle between selections) ANLG CT (Analog Output for Count)
ENT (To select displayed option) SET LOW (Flashes to Last Value Stored)
CLR 0 (Flashing)
1 D 2 4 (As an example) 1.24 (Flashing)
(Press D for decimal) In this example 1.24 = 4mA
ENT (Low set at 1.24) SET HIGH (Flashes to Last Value Stored)
CLR 0 (Flashing)
1 0 0 D 0 (As an example) 100.0 (Flashing)
(Press D for decimal) In this example 100.0 = 20mA
ENT (High set at 100.0) RUN MODE
STEP 10: Setting Output Frequency
Press Display
D MENU Flashes then PRESET
↓
D until OUTFREQ
↓