Luna PHOENIX 1200 - Manual (Page 2)

PHOENIX TM is a trademark of Luna Innovations Incorporated.
©Luna Innovations Incorporated, Roanoke, VA
All rights reserved.
PHOENIX 1200
LTPHO1200 REV. 006 07/18//2013
PARAMETER MIN TYP MAX UNITS
Wavelength
Mode Hop Free Tuning Range 1515 1565 nm
Wavelength Set Point Resolution 0.01 pm
Absolute Accuracy 1 ±1.5 pm
Wavemeter Accuracy 2 ±0.5 pm
Wavemeter Linearity ±50 fm
Stability 10.5 pm/°C
Tuning
Tuning Rate 1 100 nm/s
Deviation from Linearity
3
±1.5 ±2 GHz
Power
Range 8 10 mW
Accuracy ±5 %
Flatness 4 ±7 ±10 %
Ripple
4
±2 %
Noise
Spectral line width
5,6
1.5 MHz
Side mode suppression ratio (nearest mode) 5 43 50 dB
Relative intensity noise
5
-152 -145 dB/Hz
Spontaneous Emission Ratio
5,7
-50 -43 dBc/nm
Inputs
Auxiliary Detectors (SM FC/APC)
Detectable Range
0.001 ~ 1.0 mW
Electrical Trigger (BNC)
“Low” voltage
“High” voltage
-0.5
+2.0
0
+3.3
+0.8
+3.8 V
Outputs
Optical Connector SM FC/APC
Electrical Sweep and Retrace Triggers (BNC)
+1 M

load
+50 M

load
+2.5
+1.7 V
Size
Mechanical 23.5 x 12 x 4.5 cm
Power Requirement
DC Voltages ±12V, +5V, +3.3V, +150V
All measurements assume warm-up time of 1.5 hrs.
1
Determined by internal NIST-traceable gas cell reference.
2 Measured after wavelength auto-calibration.
3 Over full wavelength range at 10 nm/s.
4 At 10 mW tuning at 10 nm/s over full wavelength range.
5 Measured with laser set to 1540 nm with 10 mW output power.
6 Phase noise distribution full width at half maximum at center wavelength integrated over 1 ms. Measurements indicate that the
intrinsic laser linewidth (the limit at which the integration time goes to zero) is less than 100 kHz.
7 Measured with optical spectrum analyzer set at 1 nm resolution bandwidth.
CLASS 1 LASER PRODUCT