Axis Communications Axis 211 - Manual (Page 11)

AXIS 210/210A/211/211A Installation Guide Page 11
ENGLISH ENGLISH
Adjust the image and focus
To focus the AXIS 210/210A,
unscrew the focus puller on
the lens. Adjust the focus as
required. Re-tighten the focus
puller.
To focus the AXIS 211/211A follow the instructions below.
1. From the Basic Configura-
tion page in the setup
tools, open the Focus
adjustment page.
2. Set the DC-Iris to Disabled
and click Save.
3. Unscrew the zoom puller
on the lens by turning it
anti-clockwise. Adjust the
zoom setting as required.
Re-tighten the zoom puller.
4. Unscrew the focus puller on the lens. Adjust the focus as required. Re-tighten the focus
puller.
5. From the Focus adjustment page, set the DC-Iris to Enabled and click Save.
Note:
The DC-Iris should always be disabled while focusing the camera. This opens the
iris to its maximum, which gives the smallest depth of field and thus the best
conditions for correct focusing. When the focus is set with this method it will
then be maintained in any light conditions.
Accessing the AXIS 210/210A/211/211A from the Internet
Once installed, your AXIS 210/210A/211/211A is accessible on your local network (LAN). To
access the camera from the Internet, network routers must be configured to allow incoming
traffic, which is usually done on a specific port. Please refer to the documentation for your
router for further instructions. For more information on this and other topics, visit the Axis
Support Web at www.axis.com/techsup
Focus puller
Focus puller
Zoom puller
(Tele/wide)
Focus puller