Luna Optics LN-DM50-HRSD - Manual (Page 6)

viewers, as it preserves the optical image quality and even at 20x the image
is not pixilated as with the digital zoom. To increase the image magnification
press the IMAGE button (11) on the + side and look into the ocular – you will
see the image magnification increase. At the minimum level (1.00) the image
magnification is 5x; at the maximum level (4.00) the image magnification is
20x. You can see the zoom level in the right lower corner of the image
screen once you start pressing the IMAGE button on the + side. To decrease
the image magnification, press the IMAGE button on the – side.
USING INFRARED ILLUMINATOR:
Your digital viewer is equipped with a built-in powerful Infrared illuminator
light (10). This light operates in a spectrum, which is normally invisible to a
human eye, however with the help of the CCD sensor, located inside the unit,
you will see a beam of light when looking though the ocular lens. Since the
CCD does not actively amplify the available light, you will need to utilize the
IR illuminator often in the nighttime conditions.
To turn the Infrared illuminator ON, press the Infrared illuminator button (4)
once. To turn the IR illuminator OFF press the same button again once. A
red light indicator located in the back of the unit will light up indicating the IR
Illuminator is on.
When using the infrared illuminator it is important to remember that like a
flashlight, it is brightest when used in short distances. As the distance
increases, the intensity of the infrared light fades away.
TAKING PICTURES AND RECORDING HD VIDEOS:
Your digital viewer has the ability to take pictures
and record videos onto the external Micro-SD card.
4GB card is included with your unit and it is already
installed into the SD-card slot. The Micro-SD card
can be upgraded up to 32GB, which is especially
useful if you plan to record a lot of videos. To
change the SD-card, open the SD-card/USB
compartment (7) by sliding the latch to the right.
The door will pop open as you see on this image.
Remove the included 4GB card by pressing onto its end. It will pop out of its
slot (15) as shown on the image. Gently remove the card and replace it with
the new one by pressing it forward until it is securely locked in the slot.
Close the compartment door and lock it by sliding the latch to the left.
To take a picture, focus the unit onto the object you are viewing and with a
steady hand press the PIC button (10) once. The image is automatically
stored onto the SD card.
16
15