Aspire Digital 7530G - Manual (Page 41)

Chapter 2 31
Main
The Main screen allows the user to set the system time and date as well as enable and disable boot option
and recovery.
NOTE: The screen above is for your reference only. Actual values may differ.
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
Parameter Description Format/Option
System Time Sets the system time. The hours are displayed with 24-hour
format. Format: HH:MM:SS
(hour:minute:second)
System Date Sets the system date. Format MM/DD/
YYYY
(month/day/year)
System Memory This field reports the memory size of the system. Memory size
is fixed to 3071 MB. N/A
Extended Memory This field reports the Extended Memory size.
Memory size is fixed to 4094 MB. N/A
Video Memory Shows the video memory size. VGA Memory size=32 MB N/A
Quiet Boot Displays the logo screen while booting. Option: Enabled or
Disabled
Network Boot Enables, disables the system boot from LAN (remote server). Option: Enabled or
Disabled
F12 Boot Menu Enables, disables Boot Menu during POST. Option: Disabled or
Enabled
D2D Recovery Enables, disables D2D Recovery function. The function allows
the user to create a hidden partition on hard disc drive to store
operation system and restore the system to factory defaults. Option: Enabled or
Disabled
SATA Mode Control the mode in which the SATA controller should operate. Option: AHCI Mode
or IDE Mode
Force Single Bank When enabled, limits memory DIMM to a single bank
regardless of DIMM content. Option: Disabled or
Enabled
PhoenixBIOS Setup Utility
Information Main Advanced Security Boot Power Exit
Item Specific Help
System Time [13:04:04] <Tab>, <Shift-Tab>, or
System Date [05/15/2008] <Enter> selects field.
System Memory 634 KB
Extended Memory 1790 MB
Video Memory [256 MB]
Quiet Boot: [Enabled]
Network Boot: [Enabled]
F12 Boot Menu: [Disabled]
D2D Recovery: [Enabled]
SATA Mode: [ACHI Mode]
Force Single Bank: [Disabled]
F1 Help
↑↓
Select Item F5/F6 Change Values F9 Setup Defaults
ESC Exit ←→ Select Menu Enter Select XSub-Menu F10 Save and Exit