Lightronics IDP104 - Manual (Page 3)

Page
3 of 4
IDP-104 DMX OPTICAL ISOLATOR
Version 0.1 OWNERS MANUAL 07/13/2012
www.lightronics.com 20090526 drp
Lightronics Inc. 509 Central Drive Virginia Beach, Va 234354 757 486 3588
INSTALLATION
Diagrams in this manual show all signal and power
connections for both the portable and wall mount units.
POWER SUPPLY
The IDP-104 will operate using any external power
supply which can provide 13 - 24 Volts AC or DC at
600 mA minimum. The size of the power input
connector on the unit is 2.1mm X 5.5mm. If an
external DC power supply is used, the center pin of the
connector MUST be the NEGATIVE side of the
supply.
The power supply normally provided with unit is
13VAC, 800 mA.
OPERATION
Operation is automatic when the power supply and a
DMX input signal are connected. The front panel
contains a power indicator LED which is lighted when
power is applied. A "DMX VALID" LED indicator is
lighted when a DMX input signal is present.
MAINTENANCE
There are no user servicable parts in the unit. Internal
service on the unit by other than Lightronics authorized
agents will void the warranty.
Dealer and Lightronics factory personnel can help you
with operation or maintenance problems. Please read
the applicable parts of this manual before calling for
assistance.
If service is required - contact the dealer from whom
you purchased the unit or contact Lightronics, Service
Dept., 509 Central Drive, Virginia Beach, VA
23454 TEL: (757) 486-3588.