Lightronics TL4008 - Manual (Page 3)

Page 3 of 6
TL - 4008 MEMORY CONTROL CONSOLE
Revision 1.4 OWNERS MANUAL 02/17/2005
www.lightronics.com
Lightronics Inc. 509 Central Drive Virginia Beach, VA 23454 757 486 3588
INITIAL SETUP
X
FADERS
Y
FADERS
BLACK
OUT
MOMENTARY (BUMP) BUTTONS
RECORD
GRAND
MASTER
Y MODE
SELECT
CROSS
FADERS
CHASE
RATE
CHASE
SELECTORS
CHASE RESET (Resets chases to the factory programmed defaults): Remove power from the unit. Hold down
the CHASE 1 and CHASE 2 buttons. Apply power to the unit while holding these buttons down. Continue to hold
down the buttons for approximately 5 seconds then release.
SCENE ERASE (Clears all scenes): Remove power from the unit. Hold down the RECORD button. Apply power
to the unit while holding this button down. Continue to hold down the button for approximately 5 seconds then
release.
You should check the address settings of the dimmers before proceeding with TL-4008 operation.
OPERATING MODES
The TL-4008 is capable of operating in three different modes concerning the Y faders. Pressing the "Y MODE"
button changes the function of the Y (lower eight) faders. The selected mode is indicated by the Y mode LEDs.
The X (upper eight faders) ALWAYS control the level of channels 1 through 8.
The three operating Y modes are:
z "CH 1 - 8"
In this mode both the X and Y rows of faders control channels 1 through 8. The cross fader is
used to transfer control between X and Y.
z "CH 9 - 16"
In this mode the Y faders control channels 9 through 16.
z "SCENE 1 - 8" In this mode the Y faders control the intensity of 8 recorded scenes.