Magnum Venus Plastech PATRIOT HV PAT-LS-49090 - Manual (Page 20)

Patriot Fluid Section Manual PAT-LS-49090
Rev. 10/2012 Page | 20
9. Lightly lubricate a new O-Ring with Red Grease and install over the Piston
Bushing into the grove on the Inlet Body.
• Fluid Rod & Piston Assembly –
10. Properly clean Piston, Fluid Rod and Piston Valve, check ball seat area of the
Piston Valve for damage or debris.
11. Install a new O-Ring on the Piston Valve, lubricate O-Ring and threads with Red
Grease (6706-2-1).
12. Lightly grease the Piston Ball with Red Grease and place in the Piston Valve.
13. Install the Spring onto the Piston Ball, narrow side against the Ball.
14. Place the back of the Spring Retainer on top of the Spring and into the grove in
the Piston Valve, using a pair of Pliers squeeze the Spring Retainer and push the
front into the groove.
15. Screw the Piston Valve Assembly into the Piston Body and tighten firmly. Check
that the Fluid Rod is tightened onto the Piston Body.
NOTE: Use care not to drop the Piston Ball as it will be damaged.