Magnum Venus Plastech System One FRP Start-Up Sheet Quick List Instructions - Manual

FRP SystemOne
Pumping System
Start-Up Sheet
Quick List Instructions
1. Check & fill solvent system
2. Check & fill resin &
catalyst supply
3. Place suction wand in
resin supply
4. Prime resin pump
5. Prime catalyst pump and
set catalyst percentage
6. Check system for fluid leaks
7. Set air pressure to
gun/chopper
8. Install turbulent mixer in
mix chamber
9. Select spray tip, flow nozzle
or convergence tip
10. Check chopper motor,
rubber roller adjustment
11. Attach chopper cover & chute
12. Adjust fan pattern
13. Adjust chop pattern
14. See installation sheet and
manual for further instructions
Part No. M1100-1-2
Daily Settings:
Solvent Pressure ________________
Gun Pressure ________________
Pump Pressure ________________
Nozzle P/N ________________
Catalyst % ________________