Magnum Venus Plastech UNIVERSAL PROPORTIONER - Manual (Page 5)

UPLS SYSTEM OVERVIEW
UP-XX-XX-XX
MAGNUM VENUS PLASTECH REV 1.00
APRIL 2010 PAGE 5
MVP Universal Proportioner
CHAPTER 1-Introduction and General Information
The Universal Proportioner as the description implies is available in a number of
configurations depending on materials used and customer requirements. In the event
the customer’s process and materials change, the system can be converted to handle
almost all thermoset resins and application with hardware and fluid section conversions.
Generally, this system is for two part Epoxy and Urethane resin systems for pour,
closed molding and spray applications.
(Note: To avoid confusion, manuals will only include assembly drawings and
rebuild instructions for the components included in unit purchase.)
Third component options are also available for low percentage down stream mixing of
additives which will require an additional bolt-on linkage drive package.