Magnum Venus Plastech Pro Rider Gel Coater - Manual (Page 16)

Pro Rider Operations Manual
Rev. 09/2012 Page | 16
Getting Started:
Air Requirements:
Clean, dry compressed air must be available at 90 – 100 psi (6 – 7 bar) and a minimum
volume of 10 CFM (0.3 m
3
). Air must be provided through an air hose with a diameter
of 0.5 inch (1.3 cm) or greater.
Lubrication:
Throughout this manual, directions are given for lubricating various parts of the Pro
Pump. There are three types of lubricant used:
If the part contacts resin, use MVP Red Grease (6706-2-1).
If the part is located where it will contact air, use Lubriplate
®
(08465).
Throat Seal Oil (TSL-3200) used in the oil reservoir of the pump.
Other Supplies:
Solvent for cleaning.
A small Chip / Paint Brush for cleaning.
Small cup or container for the solvent.
Wet Gel Gauge to determine Gel Coat thickness.