Magnum Venus Plastech CB-6000-RGT Metric Units PROGRAMMING - Manual (Page 13)

12
Step 4) Push the DOWN CURSOR button and the display will change to this:
Step 5) Push the DOWN CURSOR button and the display will change to this:
Step 6) Push the DOWN CURSOR button and the display will change to this:
This is the decimal point setting for the display in the RUN mode. It is
initially set at the factory to +- 0.10 kilograms. If you desire more accuracy,
push the RIGHT CURSOR button until you achieve the decimal point
location you desire.
NOTE: When changing the decimal point setting it is also necessary to
change the calibration number (Step 7) by a corresponding factor.
Step 7) Push the DOWN CURSOR button and the display will change to this:
This is the calibration number for a HVLS-1000 High Volume Resin Pump
dispensing resin with a specific gravity of 1.08 and is preset by MVP. This
value is intended to be used with a one place decimal display and is
accurate to +- 0.10 kilograms. See Chart B for calibration numbers for other
specific gravities and the VLS-4600 pump.